99久久国产免费福利_瑜伽裤国产一区二区三区_丝袜人妻无码专区视频_国产美女视频国产视视频

1．金屬剪切機 設備應定人操作，其他人未經培訓不得任意使用。

2．開車前應檢查各部位是否正常，緊固件是否牢固。 　　

3．禁止剪切未經退火的鋼件、鑄鐵件、軟質金屬件、過薄的工件、長度小于100毫米的工件，以及超過剪刀長度的工件。 　　

4．操作時，人體不準接近設備的傳動部分及刀口，并應注意周圍人員的安全，防止料翹起傷人。剪切時應盡量將料靠近刀里邊剪切。剪較短料時，不得用手持工件送料，應采用夾鉗送料。 　　

5．金屬剪切機 設備運轉時，操作人員不得擅自離開崗位，工作完畢或暫離崗位時，應切斷電源。

      

本文由金屬剪切機、廢鋼打包機廠家江陰市鳴澄液壓機械有限公司整理提供，更多資訊請?jiān)L問：tongchuangbio.com 

 

1. The equipment should be during the operation, must not use any others without training.2. Before driving should check whether each part is normal, whether the fasteners firm.3. Prohibit shear without annealing of steel, cast iron pieces, soft metal pieces, a thin work-piece, length of less than 100 mm, the length of the workpiece and more than scissors.4. Operation, transmission part of the human body are not allowed to be close to the equipment and the blade, should pay attention to the surrounding and safety of personnel, prevent cocking hurt.Shear should as far as possible when the material is knife cut inside.Short cut way, hold workpiece feeding, must not be used as clamp feeding should be adopted.5. Scrap shearing machine equipment operation, the operator shall not leave post, after work or leaving his post, shall be cut off power supply.