電話：0510-86016002
手機: 13706168527
信箱：mc@jsmcyy.com
傳真：0510-86152138
網址：tongchuangbio.com
本文由金屬剪切機、廢鋼打包機廠家江陰市鳴澄液壓機械有限公司整理提供，更多資訊請?jiān)L問：tongchuangbio.com
打包機的調整方法:
1. 帶子寬度及接合口調整當帶子寬度不勻或更換另一種寬度的帶子時，必須調整左、右插帶槽太窄時，插帶困難;太寬時，廢鋼打包機捆包后帶子接合處會搭接不齊。一般插帶槽寬度應比帶子寬度寬0.5-1毫米左右。
1. The belt width and joint mouth adjustment when band width is not well or replace another kind of the width of the belt, must adjust left and right in grooved is too narrow, inserted with difficulty; Too wide, baling press bale strap joint will lap. Generally inserted slotted width than band width should be about 0.5 1 mm wide.
2, baling press permed hair permed hair temperature adjustment of high and low temperature to influence the quality of belt joint. To make polypropylene strapping tape joint cement, knob generally in 3-5 file location. Check for permed hair permed hair temperature is appropriate, surface adhesion. If permed hair surface with white marks, the temperature is high; If permed hair surface is wet, the temperature is insufficient.
3. Press bale strapping elastic adjustment of open stage face plate, with the hand will pick the mother A hex screws loosen set above, clockwise direction for tight, otherwise it loose. After binding force is moderate, will be hex socket set screw.
4. Send belt length adjustment to send out the length of the tape is decided by sending belt length controller front panel. If the tape is too short, the easy to hand tied up, at this point, the packer usable hand to seize the lead along the direction to send belt pull the cord. But need to adjust the belt length, again to ensure the normal of the strapping machine. Packer if the belt is too long, it is not easy alignment position, press the lace and panasonic to cause belt around together to prohibit or broken.
 |
|||||
|
|
|||||
 |
|||||